Briski Business 
     Custom Furniture and Cabinetry
HomeHome
For Sale Photo Journals
Gallery Gallery
 Gallery Pen Turning
 Liniks Links
Contact us Contact_Us
This is just a test of my new Gallery System  I still need to get all my pictures of my flat work together and put into the system.  If you are craving to see more pitcures you can check my In Progress pictures, or for finished work you can check out my Pen Gallery or my other turnings.

Description  
Desk Clock made from Maple burl and WalnutView Larger ImageDesk Clock made from Maple burl and Walnut
Desk Clock made from Maple burl and WalnutView Larger ImageDesk Clock made from Maple burl and Walnut
Cherry Baby CradleView Larger ImageCherry Baby Cradle
Oak BookcaseView Larger ImageOak Bookcase
Oak Bookcase with door openView Larger ImageOak Bookcase with door open
12345
 
  
News

DateDescription
06/04/2007Finished Bookcase Pictures added
04/30/2007Finished Cradle Page added for Baby Cradle
04/30/2007Page 6 updated for Baby Cradle
04/30/2007Comment section added
04/29/2007Cherry Baby Cradle Finished!
123
Have a comment, Leave it here.

Name:
Email:**
Comment:
DateNameComments
07/14/2007DavidWhat I ended up using was a couple rollerblade bearings, steel rod and some rare earth magnets. In the Cradle side I drilled a hole with a forsner bit the right size for the outer diameter of the bearing. then without moving anything I changed the bit to the size of the rare earth magnet (3/8 or 1/2 i forget which) I then glued the magnet into the hole. On the mating tower I drilled a hole to fit the steel rod (3/8” I think). I did some testing to make sure the rods were long enough so that when assembled you couldn’t pull out the rods without unbolting to towers from the bottom streatcher. I glued the rods in the tower side and the magnet would pull it though the bearing and hold it tight. I also put 2 nylon washers in between to prevent the towers from rubbing on the sides of the cradle.
07/14/2007RonI'm going to attempt a similar cradle for my sister, how do you join the cradle to the base for the pivots?
04/30/2007DavidWelcome to my website. I am glad you took the time to stop by. Please add any comments you would like. There may be a delay of up to 1 day before your new comments show up.
*Comments will be sent for approval before being added to website.
** Email is optional and will only be used to respond to you if your comment requires it. It will never be used or sold for advertising.


Last Updated 4/30/07